Getting error like "ST-LINK error (DEV_TARGET_NOT_HALTED)" while tried to connect my device to pc through STLINK
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-11-11 3:00 AM
This discussion is locked. Please start a new topic to ask your question.
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-11-11 6:47 AM
Hello @Kp.1​ and welcome to the Community :)
Which CubeProgrammer version used ?
You can try to connect in "under reset" mode, and check your USB cable, connectors.
Imen
When your question is answered, please close this topic by clicking "Accept as Solution".
Thanks
Imen
Thanks
Imen
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2021-11-29 10:53 AM
Hi @Kp.1​ ,
Were you able to resolve this issue ?
Please share the final solution you found and mark the reply as Best answer.
If you still have issues, please share more details to your post in order to help you.
Imen
When your question is answered, please close this topic by clicking "Accept as Solution".
Thanks
Imen
Thanks
Imen
