Sensor-less mode

jean239955_st · ‎2012-09-24

Posted on September 24, 2012 at 14:56

Hello,

I have chosen with st workbench, the sensor-less mode. With this mode, can I leave the connectors of hall1, hall2, hall3 and supply (5v) for sensors not connected on motor without risking their destruction ?

Regards,

bille.stello · ‎2012-11-12

Posted on November 12, 2012 at 16:27

Sure!

In drive management -> Speed/position fdbck management you can select which of the speed/position sensors is actuallyused by the algorithm to compute rotor position and thus for driving the motor. It's not going to destroy the sensors.

Best REgards,

Billino