STR710 writing to it's own flash memory

ezanen9 · ‎2005-11-23

Posted on November 24, 2005 at 04:07

ezanen9 · ‎2005-11-06

Posted on November 07, 2005 at 05:20

Hi all,

I have to write a few calibration values to non volatile memory. The calibartion values come from a routine that in only called once after installation of the device. These values have to be available after a reboot of the microcontroller.

Is it possible that the str710 microcontroller writes for example integer values to it's own flash memory?

Regards,

Jimmey

ben2 · ‎2005-11-06

Posted on November 07, 2005 at 07:03

You can use Bank 1(16k) for this purpose. I think there have been some examples posted on here, if you do a search.

ezanen9 · ‎2005-11-23

Posted on November 24, 2005 at 04:07

Hi, thanks for your answer.

How does it look when I want to write a few integers variables to the flash in C code? Do I have to allocate memory or can I write to a specific adress directly?

Regards,

Jimmey