Hi,
We recently purchased few VD55G1 camera sensors along with Camera EVK kit and breakout board for Raspberry Pi. I intend to use it with Ambig Microcontroller. I downloaded Brighsense EVK software kit to figure out settings. I am referring to file attached below to figure out the settings intended for proper operation. Following these instructions in section 5.3 on page 6 and section 9 (FW_PATCH section) on page 10, it recommends, to send PATCH_AND_BOOT command followed by BOOT Command. When I send these instructions it times out with logs attached as below.
It would be really helpful if you could help us with newest version of driver code which help us get started.
Regards,
Karthik
