Hi all
I am using Bluenrg m2sp chip as Network co -processor , and its acting as a Peripheral device , and st ble sensor app acts like Central
Bluenrg m2sp chip interface with External host Controller using uart with 115200 baud rate .
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2021-01-07 06:06 AM
The problem statement as below.
when i trying to read particular characteristic i am getting invalid command from bluenrg2chip to host microcontroller .
here i attaching invalid command from chip ,
how to resolve this , this not occur regularly but its occur in random wise during this situation , sensor app will hang and its disconnected , how to resolve this .
can any one provide the solution for this .
Labels:
- Labels:
-
BLE Mesh
0 REPLIES 0