Generate SPC5 application problem

[ilcontefabio]

Hi

I'm working with SPC570 and SPC5 Studio, version: 5.8.1 with installed the SPC5Studio patch for DMA in SPC570S DSPI lld running on Windows 11.

Very often I have a problem with Generate SPC5 Application because at the end of generation (that seems terminated with success), when I try the build SPC5 application I have these error:

make -j4 all
Compiling boot.s
Compiling crt0.s
Compiling vectors.s
Compiling ivor.s
Assembler messages:
Fatal error: can't create build/obj/boot.o: No such file or directory
make: *** [build/obj/boot.o] Error 1
make: *** Waiting for unfinished jobs....
Assembler messages:
Fatal error: can't create build/obj/vectors.o: No such file or directory
Assembler messages:
Fatal error: can't create build/obj/crt0.o: No such file or directory
make: *** [build/obj/vectors.o] Error 1
make: *** [build/obj/crt0.o] Error 1
Assembler messages:
Fatal error: can't create build/obj/ivor.o: No such file or directory
make: *** [build/obj/ivor.o] Error 1

15:51:05 Build Finished (took 3s.417ms)

I've searched on the community but I didn't find anything usefull.

Is there any workaround for this issue?

Thanks

Fabio

[Max VIZZINI]

Hi,

Try clean up and generate again the project file.

Best Regards,

AutoDevKit Team

[ilcontefabio]

Hi

sometime works but I need to generate more than ten times ...

thanks

Fabio

[Erwan YVIN · Accepted solution]

Hello ,

SPC5Studio 5.8.1 is 32 Bits version.

I recommend you to save your project

and to install SPC5Studio 6.0 64 Bits version

Generation is necessary before the compilation.

             Best regards

                            Erwan