Where can I get Android Drivers for the STA369 Amplifier Chip...?
We are using the STA369 on our bespoke computer board running Android 7.1 and we need the Android drivers.All best,Colin
Forum Posts
TSV630 Logic High Level Voltage
Hi,I'm doing a design with TSV630. VCC+ is 3.5 V and VCC- is GND and GAIN=1. What is the minimum Voltage for the SHDN pin to switch the device on? I couldn't find a formular in datasheet. In Datasheed there are only mentioned the different minimum SH...
Can I load DSP settings into STA369 via i2c
We need to tune a set of speakers to the STA369 via DSP. We would like to load the DSP settings onto the chip via i2c preferably via Android drivers in our firmware. Is this possible.Regards,Colin Aston-James
I am unable to find the datasheet for TDA7496T which comes in DIP package
Datasheets are available for TDA7496, TDA7496L, but i couldn't find the datasheet for TDA7496T
Change the internal resistance of "2STBN15D100"
Good morning.The internal resistance of "2STBN15D100" is described in the datasheet as shown below.By the way, if you actually measure the resistance between Base(1) and Emitter(3), it will measure around 12K ohm.I think that the data sheet will meas...
PCM1704 +20V power supply issue
The PCM1704 DAC chip was overdriven by +20V power supply and dead. Does anyone know if the clocker connected to the DAC was also damaged by the +20V stress?
Is there a spice model for the STGD5NB120...?
I'm trying to simulate a new high Voltage pulse generator for one of our instruments and considering the use of a IGBT. Are there any spice models available for this or similar parts...?