Posted on May 17, 2011 at 09:55Hi
My UART0 is sending very well, but it cant receive nothing! :|
Can anyone give a tip please?
Thanks
:o
here is the code:
UART_InitTypeDef st_UART0;
GPIO_InitTypeDef GPIO_InitStructure, GPIO_InitStructure2;
/* Enable the GPIO3 Clock */
SCU_APBPeriphClockConfig( __GPIO3, ENABLE );
SCU_APBPeriphReset(__GPIO3, DISABLE);
SCU_APBPeriphClockConfig( __GPIO5, ENABLE );
SCU_APBPeriphReset(__GPIO5, DISABLE);
SCU_APBPeriphClockConfig(__UART0, ENABLE);
SCU_APBPeriphReset(__UART0, DISABLE);
/* Configure UART1_Rx pin GPIO5.1 */
GPIO_InitStructure.GPIO_Direction = GPIO_PinInput;
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_1;
GPIO_InitStructure.GPIO_Type = GPIO_Type_PushPull ;
//GPIO_InitStructure.GPIO_IPConnected = GPIO_IPConnected_Enable;
GPIO_InitStructure.GPIO_Alternate = GPIO_InputAlt1;
GPIO_Init( GPIO5, &GPIO_InitStructure);
/* Configure UART1_Tx pin GPIO3.4 */
GPIO_InitStructure2.GPIO_Direction = GPIO_PinOutput;
GPIO_InitStructure2.GPIO_Pin = GPIO_Pin_4;
GPIO_InitStructure2.GPIO_Type = GPIO_Type_PushPull ;
GPIO_InitStructure2.GPIO_IPConnected = GPIO_IPConnected_Enable;
GPIO_InitStructure2.GPIO_Alternate = GPIO_OutputAlt3;
GPIO_Init( GPIO3, &GPIO_InitStructure2 );
UART_DeInit(UART0);
st_UART0.UART_WordLength = UART_WordLength_8D;
st_UART0.UART_StopBits = UART_StopBits_1;
st_UART0.UART_Parity = UART_Parity_Odd ;
st_UART0.UART_BaudRate =115200;
st_UART0.UART_HardwareFlowControl = UART_HardwareFlowControl_None;
st_UART0.UART_Mode = UART_Mode_Tx_Rx;
st_UART0.UART_FIFO = UART_FIFO_Disable;
// st_UART0.UART_TxFIFOLevel = UART_FIFOLevel_1_2;
//st_UART0.UART_RxFIFOLevel = UART_FIFOLevel_1_2;
UART0->ICR = 0x3ff; // CLEAR_ALL_INTERRUPTS
UART_ITConfig(UART0, 0x10, ENABLE);/// just RXIM its 0x10
UART_LoopBackConfig(UART0, DISABLE);
UART_IrDACmd(IrDA0, DISABLE);
UART_Init(UART0, &st_UART0);
UART_Cmd(UART0, ENABLE);
VIC_Config(UART0_ITLine, VIC_IRQ, 10);
VIC_ITCmd(UART0_ITLine, ENABLE);
