Posted on November 27, 2017 at 14:58Hello,i'm going to read SDADC1, SDADC2, SDADC3 (stm32f373) in continuous mode with DMA,Setup: Regular conversion, multimode disable,software start for SDADC1, Synchronous trigger for SDADC2, SDADC3.Each SDADC conf...

Posted on October 10, 2016 at 13:12Hello, should i connect 3V battery to Vss or Vssa for RTC backup (external 32768 resonator)? #too-vague #stm32-vbat-rtc

Posted on September 22, 2016 at 15:19Hello, I have a project based on stm32f373, I'd like to trigger sdadc conversion with RTC synchronyzed frequency, are there any solutions to do this without external routing MCO output(LSE) -> Timer Input -> Trig...

Posted on March 23, 2016 at 15:11Hello, I'd like to monitor battery voltage (V~8volts) using comparator and voltage devider with two resistors (1-10M). Coud you please specify analog comparator input impedance, so i can select appropriate resistor v...

Posted on February 02, 2016 at 10:34Hello, cubemx shows that baud rate for USART clocking from LSE  must be between 32 Bits/s and 131.062 KBits/s.  Is it CubeMX bug or L-series allows clocking regular USART (not LPUART) up to 130KBits?  MCU: stm32L0...