About GioBytem

GioBytem · 2024-11-22

Hello everyone,I'm trying to debug firmware on a custom ST32H750XBH6 board. Once I configured the MCU on StmCubeMX to act as a USB_OTG_HS after flashing the firmware the ST-link stopped working and it gave me the error message:Target no device found:...

GioBytem · 2024-11-27

I see only one connector Type micro-B, which is also labeled as "USB_STLINK". So I guessed it was used for both and that it cannot handle communication for st-link and USB at the same time... am I wrong?

GioBytem · 2024-11-27

Then can the MCU be reset with the bootloader?

GioBytem · 2024-11-27

No, okay. I figured out what the problem was on the custom board. My SWD connector was wrong, and it's working fine now that I've changed it.The problem with the NUCLEO remains, after flashing the Nucleo to act as USB_Device the USB cable that you us...

GioBytem · 2024-11-25

I flashed another firmware on the custom board, but on the Nucleo board, I initialized the Nucleo myself only activating the USB_OTG_HS peripheral to make the Nucleo a USB Device. After flashing the Nucleo once successfully, I can not flash it again...

User statistics

User Activity

ST-link stop working after configuring Nucleo-G0B1RE as USB Device

Re: ST-link stop working after configuring ST32H7 as USB Device

Re: ST-link stop working after configuring ST32H7 as USB Device

Re: ST-link stop working after configuring ST32H7 as USB Device

Re: ST-link stop working after configuring ST32H7 as USB Device