About degaus

degaus · 2024-11-17

Hello everyone,I have designed a custom board with the STM32G0B1CET6N but I cannot connect to the nucleo st-link programmer.I have removed the two jumpers from the nucleo board but when connecting to the board it doesn't get recognised by the ST-Link...

degaus · 2024-11-17

Hi MM..1, Thanks again for your help. I have connected as your suggestion and now I do get a different error.Need more investigation...I may get the board re-done with the VDDIO2 and VSS connected this time, just to make sure that the flying wires ar...

degaus · 2024-11-17

Hi MM..1, Thanks for the reply.The link is working as normal with jumpers on, also it is working fine with jumpers off on another custom board (L010 chip). I have attached the picture with the jumpers off. I think I need to get a new board done with ...

degaus · 2024-11-17

Hi Pavel, Thank you for your reply, I am not actually hacking a nucleo, I am only using the built in st-link to try to program my custom board. I have actually a ST-LinkV3, but I have the same issue.I am trying to understand what else I am missing, o...

degaus · 2024-11-17

Hello MM..1, Thank you for your prompt reply!Yes, I did noticed that mistake and I have put a temporary cable with the decoupling capacitors. Unfortunately it doesn't seem to work still. I will check that connection again in case there is a bad solde...

User statistics

User Activity

Cannot connect to STM32G0B1 custom board

Re: Cannot connect to STM32G0B1 custom board

Re: Cannot connect to STM32G0B1 custom board

Re: Cannot connect to STM32G0B1 custom board

Re: Cannot connect to STM32G0B1 custom board