About CalebJ

CalebJ · 2024-09-23

Hi,I am using the STM32WB15CC chip in a stm32WB1mmc module on a custom pcb. I need to write to a non volatile uint8_t variable 70,000 times over the lifetime of the device. I have been using following guide ( https://community.st.com/t5/stm32-mcus/p...

CalebJ · 2024-09-27

Is there a way to do this if you do not have the SEGGER J-Link and just the ST-Link V2?

CalebJ · 2024-09-27

I don't have a geniune ST-Link sorry.Yup, here are my steps:Erase entire flash using the "Full chip erase" button in the STM32CubeProgrammer.Click the "Disconnect" button in STM32CubeProgrammer.Open the STM32CubeIDE and build the project.Click the "R...

CalebJ · 2024-09-24

I have added functionality to toggle an led in the main while loop after all the eeprom code has executed successfully. This was to check if the eeprom code still worked after a reset. It turns out it does.I am using the 1.16.1 version of the STM32Cu...

User statistics

User Activity

EEPROM Emulation works, but to program again I have to erase the entire flash.

Re: How to clear the total Chip when Reprogramming the MCU; Using STM32CubeIde and a Segger Jlink ;

Re: EEPROM Emulation works, but to program again I have to erase the entire flash.

Re: EEPROM Emulation works, but to program again I have to erase the entire flash.