About samruddhi_daithankar

samruddhi_daithankar · 2024-07-11

I am trying to program the STM8S001J3 microcontroller, on a custom board. I am using ST Visual Programmer tool for flashing the program but I’m running into the following error continuously.I have tried using both ST-Link/V2(A) and ST-Link/V2(A) ISOL...

samruddhi_daithankar · 2024-07-11

I am using the ST discovery board, which has STM8S003K3. I have written a code that generates a PWM pulse when ADC senses that the input voltage is higher than a threshold value. I have tested this program with a Potentiometer and verified the wavefo...

samruddhi_daithankar · 2024-07-15

Hello, I tried this, and I still was not able to flash the program. What else do you think might cause this?

samruddhi_daithankar · 2024-07-11

In my design, SWIM pin is also being used as PWM output. in that case, will I not be able to debug it at all? Section 4.2 of the Datasheet mentions:As the NRST pin is not available on this device, if the SWIM pin should be used with the I/O pin funct...

User statistics

User Activity

STM8S001J3: Unable to communicate with the device

Unable to generate a PWM pulse

Re: STM8S001J3: Unable to communicate with the device

Re: STM8S001J3: Unable to communicate with the device