Posted on May 03, 2016 at 15:27Hi all,Regarding to L6480 datasheet, STEP_MODE register has SYNC_EN bit and SYNC_SEL. if SYNC_EN bit is set high, then SYNC output provides a clock signal according to the SYNC_SEL parameter. the sync signal is obtaine...

Posted on April 22, 2015 at 19:07The original post was too long to process during our migration. Please click on the attachment to read the original post.

Posted on April 16, 2015 at 16:16In application note AN4355, overcurrent detection page 18 and stall detection page 21, application note writes two equationsEquation 1: IOCDth = VOCDth � Rds(ON)Equation 2: ISTALLth = VSTALLth � Rds(ON)Why current is...

Posted on March 04, 2015 at 15:30Hi, I bought EVAL6480H board which is R1.1 version. On the board, J6 pin 4 labeled GND, however, if you look at the layout, pin 4 actually tied to VS. I used DMM to measure continuity to verify that GND connects to ...