About STDoom

STDoom · 2024-04-20

Hi All I'm new to STM32 and I'm exploring it a little bit. I think I've found an issue in the HAL in configuration Line is referred to the external interrupt line to be connected. it is configured in the BSP with (void)HAL_EXTI_GetHandle(&hpb_e...

STDoom · 2024-04-20

HiI'm trying to understand how to configure the hal/peripheral to evaluate the CRC32 MPEG2 over a block of datas.I'm comparing the result with this site where as input I've used the vector 0x01, 0x01. Expected result is 0xD66FB816https://crccalc.com/...

STDoom · 2024-04-22

here the example. I've created a new empty project for the selected board Nucleo C031C6 adding the BSP selecting the led + the button (NO VCM) and generate the example code.For some reason it doesn't run on my board as is so I've changed the clock se...

STDoom · 2024-04-22

HiI've just created the example for the demoboard NUCLEO- STM32C0.If it might help later I'll copy here the project but I think was this one (https://wiki.st.com/stm32mcu/wiki/Getting_started_with_EXTI)

STDoom · 2024-04-20

Hi TeslaPerfect! I've found the issue.

User statistics

User Activity

STM32c0. Issue in push button on external interrupt example

CRC32 MPEG2 configuration for ST32C0x1 CRC driver

Re: STM32c0. Issue in push button on external interrupt example

Re: STM32c0. Issue in push button on external interrupt example

Re: CRC32 MPEG2 configuration for ST32C0x1 CRC driver