Posted on June 21, 2018 at 20:35Hi,With the cubeMx tool, when i use usart2 , the lpuart can not be included.But when i set as bellow, is it possible to use usart2 tx/rx full duplex, and lpuart tx only ?-- as follows--Usart2TX : PA2RX: PA15LPUARTTX :...

Posted on July 05, 2017 at 14:43STEVAL-MKI155V2 coupon board,cannot find exact pin number.On silk on the board, and no layout file on st site.And on en.DM0006727d.pdf, bottom view image seems to be mirrored.Please let me know where  I can  find the ...

Posted on June 27, 2017 at 14:45Can OSC_OUT pin be used as GPIO pin when OSC_IN is used as clock input ?CubeMx shows that both of OSC_IN/OSC_OUT should used as clock pins with HSE(bypass clock source) options.

Posted on October 08, 2016 at 05:10http://www.st.com/content/ccc/resource/technical/document/datasheet/33/d4/6f/1d/df/0b/4c/6d/CD00161566.pdf/files/CD00161566.pdf/jcr:content/translations/en.CD00161566.pdfpage 12 3. To have an ADC conversion time of...

Posted on June 13, 2016 at 13:53No peripheral enabled.Only mcu is mounted and power is feed from power supply directly.Current is nearly 170 uA at MSI 1Mhz low power sleep mode.but cubeMx says 65 uA.In other modes, current is almost 100 uA more than...