About G-Poulios

G-Poulios · 2024-04-10

I am using the NUCLEO-H563ZI board and I am trying to configure the UART2 using only registers.I started by creating a fresh and simple new code with STM32CubeIDE for UART transmit because I wanted to use a simple uart_transmit function but I had tro...

G-Poulios · 2024-03-20

I am using STM32H563ZI board and trying to develop a UART communication project but I just can't figure how to connect to STM32CubeProgrammer threw UART and always get the error:" Error: Activating device: KO. Please, verify the boot mode configurati...

G-Poulios · 2024-04-15

The expectation is theHAL_UART_Transmit (&huart2, data, sizeof (data), 1000); to transmit/write to a terminal HAL_UART_Transmit (&huart2, data, sizeof (data), 1000);And as for the HAL overwriting the changes, well that's what I am asking, how can I d...

G-Poulios · 2024-04-12

Thank you but it still doesn't work static void MX_USART2_UART_Init(void) { /* USER CODE BEGIN USART2_Init 0 */ RCC->AHB2ENR |= RCC_AHB2ENR_GPIODEN; // ENABLE GPIO PORT D CLOCK (BIT 0) RCC->APB1LENR |= RCC_APB1LENR_USART2EN; ...

G-Poulios · 2024-03-20

I want to be able to both configure, transmit and receive data directly from the registers:void configPinMode(void) { // RESET PIN MODES GPIOD->MODER &= ~((3u << 10) // CLEAR PD5 |(3u << 12)); // CLEAR PD6 // SET...

User statistics

User Activity

UART cosfiguration directly with registers, NUCLEO-H563ZI board

STM32CubeProgrammer UART communication error " Error: Activating device: KO. Please, verify the..."

Re: UART cosfiguration directly with registers, NUCLEO-H563ZI board

Re: UART cosfiguration directly with registers, NUCLEO-H563ZI board

Re: STM32CubeProgrammer UART communication error " Error: Activating device: KO. Please, verify