User Activity

Hi @Peter BENSCH I am using the controller STM32G491MCT controller for my development project.I am running out of GPIO pins.I am planning to use PC13 to drive the level translator SN74LV4T125 for sending serial clock and data signals from my master d...
 Hi @Igor Cesko I am experiencing connection issues with STM Cube programmer when connecting ST LINK debugger.The controller part number i am using is STM32G491MCT.Getting "Error Target device held under rest", I can connect only if I change the ST l...
Hi @Peter BENSCH Greetings of the day!I am using the controller STM32G491MCT for one of my development project. It is given in the datasheet that the VIL of the FT pin is 0.25*VDD & 0.3*VDD. My input signal fall within the range of 0.753V to 3.83V.Co...
Hi team  Greetings of the day! We are planning to perform board programming with STM32 controllers through command line toolset. Could you please provide us customized command lines for programming through GUI. Below listed are the two controllers we...
shall we able to configure stm32g431mb gpio to high impedence state when configured as output pin. We need to access output pin in tristate mode 
Kudos given to