About DeemDeem52

DeemDeem52 · 2024-05-11

Hello, I'm working on a project for a Nucleo board for which I'm trying to use VSCode. I've installed the relevant extensions, and building and running the project had been working, but suddenly (after changing the .ioc file in CubeMX) it stopped wo...

DeemDeem52 · 2024-03-12

Hello;I am working with STM32CubeIDE, trying to connect a Nucleo-L4R5ZI board to an ADCS chip using I2C. The method of communication is very strange, requiring: [start condition] - [controller sends two bytes] - [start condition] - [controller sends ...

DeemDeem52 · 2024-05-14

Hey there! Thanks for the information.I found the solution -- when I updated the code using CubeMX in the .ioc file, it removed a number of lines from the makefile which were under C_SOURCES, which without those, VSCode didnt't know where to find the...

DeemDeem52 · 2024-05-12

Thanks for your reply. I still don't really understand what the error is, but I have attached the full log as a .txt file. I'm assuming it's some sort of flag issue, but I don't know.

DeemDeem52 · 2024-03-13

Thank you very much! This is definitely the key observation I was missing.

DeemDeem52 · 2024-03-13

That's good to know... but in this case, the "Device Address" (0xAE the first time, and 0xAF the second time) is not the same as the actual device address (0x57). Does that change the function I need to use?

User statistics

User Activity

VSCode STM32 error: ld returned 1 exit status

Issues with I2C Direction Changes

Re: VSCode STM32 error: ld returned 1 exit status

Re: VSCode STM32 error: ld returned 1 exit status

Re: Issues with I2C Direction Changes

Re: Issues with I2C Direction Changes