About backb0ne

backb0ne · 2023-12-08

[VERSION]: MCSDK 6.2.0 [TOOL]: MC Workbench [DETAILS]: HiI want to prototype the HSO algorithm to compare the performance with the current Observer.From a webinar I have followed last month, the requirement were:- Analog inputs all 3 motors phase vol...

backb0ne · 2023-11-22

[VERSION]: MCSDK 6.2.0 [TOOL]: Motor PROFILER v1.2.4EVALSTDRIVE101 + NUCLEO-F746ZG [DETAILS]: I have a sensorless project which work perfectly when the motor profiler option is disable. however, when the motor profiler option is enable, either the pr...

backb0ne · 2023-12-11

Hi @cedric H My mistake !I also found that - voltage measurements have to be on two ADC, AND- voltage measurement and current measurement of the same phase have to be on different ADC.If point 2 is not respected, the MCU pin mapping will not show in ...

backb0ne · 2023-12-10

Hi @cedric H Thanks for looking, really appreciate.Regards.

backb0ne · 2023-12-07

Hi @Gael A I wanted to profile another motor, and managed to successfully do the first one, but not the second one.I may have found the problem. The system doesn't like when both Open Loop and Motor Profiler are selected. It works fine when only one ...

backb0ne · 2023-11-27

Hi @cedric H Thanks for your response and for taking the time to test it on your side.To bring a bit more precision, attached is the project. I am using a custom board adapter to change couple signal allocation. I am guessing it is not link, but we ...

User statistics

User Activity

HSO Requirement

Problem with Motor profiler

Re: HSO Requirement

Re: HSO Requirement

Re: Problem with Motor profiler

Re: Problem with Motor profiler