About S3rr4

S3rr4 · 2024-04-08

Hi,I have a array of 2x5 STWBC86 on a aluminium plate to make a charging station for multiple devices. They are all connected to a common 5V source and decoupled by a small filter of Ferrite bead and MLCC.After testing them for a while i let them res...

S3rr4 · 2023-11-15

Hi there, we are trying to operate a STWBC86 on a rebuild of STDES-WBC86WTX.Eval boards are not yet available so we needed to build them with the given data on our own. when powering it up nothing happens so i assumed i need to program the supplied F...

S3rr4 · 2024-04-23

Hi,if i understand correctly Fhop is enabled by default.so you reccomend to disable Fhop feature? Best regardsStefan

S3rr4 · 2024-04-15

Hi,i will try and give you feedback asap.the WPSTUDIO doesn't let me set 0 so i will try with the minimum which is 1.

S3rr4 · 2024-04-12

Hi,don't worry.nearly got it. When i power up the TX everything runs as expexted. I can charge every kind of RX and place them and remove them very often without a problem.My issue is that when i power up the TX and let it sit without a RX for one or...

S3rr4 · 2024-04-12

Hi,thanks for the swift reply.i checked with a scope. the TX is still on (even if RX is removed). This will carry on forever until i reset the controller. Also i guess the CEP is there because of the removal of the RX on the previous charging cycle.I...

S3rr4 · 2024-04-12

Hi,i could recreate it within a day.Please find the screenshot below:as well see a shot of the mode monitor: RX and TX powers values are misleading in correlation to ICUR.I also looked at the TX Interrupt latches and did find that if i write to "Did ...

User statistics

User Activity

STWBC86 stops working after a few days

Cannot connect STWBC86 to WPSTUDIO V1.8.4

Re: STWBC86 stops working after a few days

Re: STWBC86 stops working after a few days

Re: STWBC86 stops working after a few days

Re: STWBC86 stops working after a few days

Re: STWBC86 stops working after a few days