About mich35

mich35 · 2025-01-10

Hello,I am using freertos configured by STM32CubeMx.The IWDG is activated and configured by STM32CubeMx too.I met an issue in my code but this is not the purpose of this post.Due to this issue the STM32L431 stays blocked indefinitly despite the IWDG ...

mich35 · 2024-11-27

Hello,How can I add the [-Wenum-conversion] warning check?If I check the "Warn for implicit conversion (-Wconsersion) I have many warnings from ST originated files (stm32l4xx.h) so I can not use this option....Best regardsMich

mich35 · 2024-07-01

Hello, How could I save the configuration of the STM32CubeMonitor? It is painful and dangerous to have always to set the Voltage.... Best regards Mich

mich35 · 2024-07-01

Hello,I replaced the ST-LINKV2 by the STLINK-V3PWR and I use Windows 8. The drivers are not found:Do you have drivers for Windows8 please?Best regardsMich

mich35 · 2023-12-19

Hello,How can I check that the teseo correctly receives L5 band satellite and not only L1?Is it indicated in a NMEA message?Best regardsMich

mich35 · 2025-01-10

"Nothing can block IWDG once started. FreeRTOS cannot stop IWDG."It would wonderfull if true.Obviously something blocks it.Thanks for the remark that this is not related to freeRTOS but I still have no explanation.Depending of the read memory address...

mich35 · 2025-01-10

Hello Imen,How a task in FreeRTOS can block the IWDG?When the issue occurs (a read at a bad memory address) the IWDG is never refresh so it should trig.But it does not trig.How can this occur?What do you mean by "You can check with a logic analyzer t...

mich35 · 2024-11-27

Do you have any idea how to set this option because if I only wrote [-Wenum-conversion] in the other flags of the miscellaneous, i have the result:arm-none-eabi-gcc: warning: [-Wenum-conversion]: linker input file unused because linking not done

mich35 · 2024-07-02

Hello,STM32CubeMonitor-Power - v1.2.1 + STLINK-V3PWR.I would like to supply the board with the probe OUT to download firmware to the target.And afterwards measure the current...Best regardsMich

mich35 · 2023-12-19

Thanks a lot Tesla,Can I use the same $PSTMSETPAR,1122,4 command for teseo-liv4f?This command is not listed in the UM3009 document.....Is this command for NMEA-0183 V4.10 or V4.11?Best regardsMich

User statistics

User Activity

Can freertos block IWDG?

How can I add the [-Wenum-conversion] warning check?

STM32CubeMonitor save config

STLINK-V3PWR windows 8 drivers

teseo: how to check L5 band reception

Re: Can freertos block IWDG?

Re: Can freertos block IWDG?

Re: How can I add the [-Wenum-conversion] warning check?

Re: STM32CubeMonitor save config

Re: teseo: how to check L5 band reception