Posted on September 01, 2015 at 22:16HI, I am using an L6470 and have a situation where I must stop motion immediately if an obstruction (think someone's hand) crosses an IR beam. Motion must stop immediately and not via any commands since there can...

Posted on August 21, 2014 at 22:41after performing a few sensor seeks using the ReleaseSW() and GoUntil() commands i have noticed that they do not use the same acceleration/deceleration. GoUntil() uses the programmed values, ReleaseSW() uses somethi...

Posted on July 21, 2014 at 23:12i've been using the L6470 driver successfully but have noticed that i get step loss on the a and b bridge. the data sheet indicates that when this happens the appropriate bits in the status register get set. unfortuna...