About SeosaphM

SeosaphM · 2024-03-24

Thanks to SofLit, I managed to create a new project from a configured .ioc file. The next objectif is to see if I can read CAN data from an instrument cluster I have on my bench.I am attempting to read the data from STMCubeProgrammer. I can connect t...

SeosaphM · 2024-03-22

Hello, I am very new to micro electronics. I have been trying to set up reading CAN bus messages using my Nucleo board with a can tranceiver SN65HVD230.I have found many examples , but not for the F334R8T6Nucleo. I attempted to export numerous exampl...

SeosaphM · 2024-04-03

Thanks for your message. I am attempting to eventually run SavvyCan from my Nucleo Board, but thought CubeProgrammer did a similar job showing data being streamed Live. Not....Since I know nothing about Filter Configurations, I am following STM32 CAN...

SeosaphM · 2024-03-24

Thank you for your response and .ioc file with parameters configured. I managed to create a new project from STM .ioc file for my NucleoF334R8 boad.

SeosaphM · 2024-03-23

Thank you for the links. I have built the example that you attached in CubeMX. This is baby steps for me, and aim to read CAN messages from an instrument cluster to start with. I am now configuring the CAN wiring setups.I am also trying to understand...

User statistics

User Activity

CAN Filter Configuration

NucleoF334R8T6 Can bus reader

Re: CAN Filter Configuration

Re: NucleoF334R8T6 Can bus reader

Re: NucleoF334R8T6 Can bus reader