About Anassoumi

Anassoumi · 2024-11-11

Hello everyone,I'm working on a project that involves UART communication between an STM32f429 and an nRF5340DK, with the nRF5340 acting as the UART transmitter and the STM32 as the receiver. However, I've been facing issues where the data received on...

Anassoumi · 2024-05-22

Hi, I'm using an STM32U5 DK and I'm comfortable with TouchGFX and its code generation features. However, I'm struggling to achieve the same results manually, as there are many changes in both hardware configuration and TouchGFX files. Can anyone guid...

Anassoumi · 2024-04-17

I’ve been working on a project for a while and initially generated the code only once at the beginning to set up the hardware configuration. Recently, I updated STM32CubeIDE from version 1.14.1 to 1.15.0. After updating, I regenerated the code withou...

Anassoumi · 2024-03-04

Hello Community,I'm currently facing an issue with entering the USART bootloader mode on my STM32U5 development kit (STM32U5A9JDK). Despite following the standard procedure, the device refuses to enter bootloader mode, and I'm hoping someone here mig...

Anassoumi · 2024-02-12

Hello everyone,I'm currently working with a custom board that utilizes the STM32U599 microcontroller, and I'm attempting to establish communication with an SD card. The IDE I'm using presents the option of FileX alongside ThreadX; however, my applica...

Anassoumi · 2024-11-11

The code is very basic just to prove the concept : the init function :void MX_USART1_UART_Init(void){ /* USER CODE BEGIN USART1_Init 0 */ /* USER CODE END USART1_Init 0 */ /* USER CODE BEGIN USART1_Init 1 */ /* USER CODE END USART1_Init 1 */huart1.In...

Anassoumi · 2024-05-25

I've followed all the required steps, and from a hardware initialization perspective, everything seems correct—I've even aligned it with the example project in TouchGFX Designer, except for the OctoSPI initialization for MX25UM51245G. My goal is simp...

Anassoumi · 2024-04-22

I've identified the root cause of my ADC issue related to FreeRTOS. It turns out that the ASV bit in the PWR->SVMCR register was never enabled during the initialization phase. This bit is essential for the proper operation of analog peripherals ... I...

Anassoumi · 2024-04-22

Can someone who has access to an stm32u5 do a simple test and confirm that adc works with freertos on the latest version of cube ide ?

Anassoumi · 2024-04-22

Hello, increasing the heap and stack sizes hasn't resolved the issue. I've tried starting a new project with just the ADC enabled, and it works perfectly until I activate FreeRTOS; then the ADC stops working. I've ensured that both the stack and heap...

User statistics

User Activity

UART Communication Sync Issues Between STM32 and nRF5340DK

setup stm32u59 without touchgfx imported example

ADC doesn't work after code gneration

USART bootloader not working on stm32u59

no FATFS in stm32u59 ?

Re: UART Communication Sync Issues Between STM32 and nRF5340DK

Re: setup stm32u59 without touchgfx imported example

Re: ADC doesn't work after code gneration

Re: ADC doesn't work after code gneration

Re: ADC doesn't work after code gneration