About TVan .2

TVan .2 · 2020-11-09

I am getting this error, while the setup in cubemx is for this chip... Using SW4STM32.Wrong device detected, check your project and the board(s) connected Open On-Chip Debugger 0.10.0+dev-00021-g524e8c8 (2019-04-12-08:48) Licensed under GNU GPL v2 Fo...

TVan .2 · 2020-05-16

How to change NRST pin to a interrupt input pin on the G031?

TVan .2 · 2020-03-07

TVan .2 · 2020-05-18

Dear,We need it as PA0, since we need to be able to call a wakeup and we also need I2C2, so that is the only option. Just using the chip how it should be used!GreetingsThomas Van Aken

TVan .2 · 2020-05-17

STM32Cube_FW_G0_V1.3.0\Projects\STM32G0316-DISCO\Demonstrations --> check this one + docu

TVan .2 · 2020-05-16

I read that it could be an interrupt input also or wake-up. I tought the example also showed this function, but I don't understand how.

TVan .2 · 2020-03-30

DearThis is DTR and DTS, my FT234XD doesn't have those. Only RTS and DTR.Does this method work without any special software?GreetingsThomas Van Aken

TVan .2 · 2020-03-29

@Imen DAHMEN any answer yet how to do this and with what tool? So auto reset and auto bootloader with dtr and rts?

User statistics

User Activity

Flash problem (original STLINK & IC from DigiKey)

How to change NRST pin to a interrupt input pin on the G031?

Flashing STEVAL-MKSBOX1V1 with STLINK-V3 not working?

Re: How to change NRST pin to a interrupt input pin on the G031?

Re: How to change NRST pin to a interrupt input pin on the G031?

Re: How to change NRST pin to a interrupt input pin on the G031?

Re: BOOT0/NRST control with DTR/RTS

Re: BOOT0/NRST control with DTR/RTS