Hello,I am trying to get the CAN Bus on a Nucleo F446RE to receive messages from an ECU, but it will not. The STM32 has been tested in loopback mode and is able to trigger the interrupt and process the data upon receiving the message, and the STM32 i...

Hello,I am designing a circuit that needs a HSE and a LSE oscillator for USB and RTC respectively, and need to solder it by hand. Would a bypass oscillators in a SOT23-5 package (i.e. the SiT2024BA-S2-33E-8.000000G and the SIT1630AE-S6-DCC-32.768G) w...

Hello,This is my first time designing a PCB for an STM32F4 microcontroller (and I only get one shot at making this board), and the specific application requires USB and a CAN-Bus. I chose a 10 MHz through-hole crystal oscillator (ABL-10.000MHz-B1U-T)...

Hello,I hate to say this, but I am completely lost in regards to programming FDCAN to receive extended ID messages from an ECU. I looked to the examples provided in the IDE as well as other questions on this forum, but am still confused. I have a str...

Hello,I have been trying for some time to get this to work. It is my understanding from the datasheet that the default values for the IC are suitable to where the acceleration and angular rates can be measured by shifting in the appropriate register ...