About PRona.1

PRona.1 · 2020-03-03

Hi All,I am quite new to LoRa so if I am in the wrong forum area I do apologise. If anyone has any information based on my issues below I would appreciate a reply.I have followed the setup guide from STMicroelectronics for the P-Nucleo-LRWAN2:I have ...

PRona.1 · 2020-02-26

PRona.1 · 2020-01-15

PRona.1 · 2020-03-27

Be sure to follow the instruction exactly if you miss a step in The Things Network Setup you will need to start again.

PRona.1 · 2020-03-27

Hi,I just dragged and dropped the file into the virtual drive it creates when connected to the PC.It should just load upload automatically then.I have zipped my .bin file for you to compare with.

PRona.1 · 2020-01-15

Hi Francesco,Thanks so much for all the information it has really helped in my evaluation of the Teseo-LIV3F and I will definitely be using it in the upcoming project.I know the STEVAL-STRKT01 is also a LoRa Tracker and I can't see the DevEUI in Tera...

PRona.1 · 2020-01-15

Hi Francesco,I have sats streaming now that I am in an open sky condition.See image below.I still can not connect using Teseo Suite Pro.Can you help with this please.

PRona.1 · 2020-01-15

Hi Francesco,Sorry for my ignorance new to gps. when you say open sky you mean outside right?So the reason I don't see sats and can not connect in Teseo-Suite Pro is because I need to be outside or atleast in view of the sky?Regards,*****

User statistics

User Activity

1: how do i get my gateway to be connected 2: do i need to use at commands on the I-Nucleo to communicate through it 3: how do i know if the I-Nucleo is sending it data? 4: how do i know if the gateway is receiving any data?

Can the STM32 Discovery Kit IOT Node be used for Sigfox communication? If so is there evaluation firware i can flash the device with to get started?

Having problems connecting my STEVAL-STRKT01 with Teseo Suite Pro 5.2 Is there a step by step guide of what to do once the eval board is un boxed?

Re: 1: how do i get my gateway to be connected 2: do i need to use at commands on the I-Nucleo to communicate through it 3: how do i know if the I-Nucleo is sending it data? 4: how do i know if the gateway is receiving any data?

Re: 1: how do i get my gateway to be connected 2: do i need to use at commands on the I-Nucleo to communicate through it 3: how do i know if the I-Nucleo is sending it data? 4: how do i know if the gateway is receiving any data?

Re: Having problems connecting my STEVAL-STRKT01 with Teseo Suite Pro 5.2 Is there a step by step guide of what to do once the eval board is un boxed?

Re: Having problems connecting my STEVAL-STRKT01 with Teseo Suite Pro 5.2 Is there a step by step guide of what to do once the eval board is un boxed?

Re: Having problems connecting my STEVAL-STRKT01 with Teseo Suite Pro 5.2 Is there a step by step guide of what to do once the eval board is un boxed?