Just got two of the WL55JC1 boards today, and while working just fine transmitting data, the usb connectors are really bad. Can barely touch the usb without it disconnecting and resetting the board..I will try and resolder the connector and see if th...

Is there any tutorials/AN for using the WiFi connectivity on the STWINKT1 board? What dashboard can i use to display sensor readings?

Hi. I just bought the new STEVAL-STWINK1 eval board and tried it out on the ST BLE android app. But i keep getting connection errors on the bluetooth and get disconnected.. I can barely finish one FFT analysis before the bluetooth bugs out and discon...

When configuring function routing on INT1/INT2 register (MD1_CFG/MD2_CFG), there is a note that says; "Activity/Inactivity interrupt mode (sleep change or sleep status) depends on the SLEEP_STATUS_ON_INT bit in SLOPE_EN (56h) register.But the SLOPE_E...

First i pull both interrupt pins to GND before power up the sensor, as recommended by the datasheet. I then configure SDO pin with pull-up using register PIN_CTRL. Then i enable the accelerometer with no second filtering stage from register CTRL1_XL....