About ADesu.2

ADesu.2 · 2023-01-24

ADesu.2 · 2023-01-24

yess u r right.

ADesu.2 · 2023-01-24

Hi @gbm ,Below attached is the error message i get.And yes u r right, ST-link v2 i am using is not the original one then.

ADesu.2 · 2023-01-24

Sharing the screen shot of error that pops up.Also, STMCubeProgrammer detects the ST Device with the same hardware setup.

ADesu.2 · 2023-01-24

Hi @Sarra.S, thankyou for your reply,I have tried both ie. using another original ST-link V2 and by resetting the BOOT0 pin. Still the code is not uploading...Just to clarify- I am programming my stm32f103c8t6 based custom made pcb with ST-Link V2 v...

User statistics

User Activity

I have tested my code in blue pill and now have made my custom pcb containing stm32f103c8t6. I am unable to program with my st link. The ettings on stm32cubeide are correct as the code gets uploaded in the bluepill. Do we have to set or reset the BOOT0.

Re: I have tested my code in blue pill and now have made my custom pcb containing stm32f103c8t6. I am unable to program with my st link. The ettings on stm32cubeide are correct as the code gets uploaded in the bluepill. Do we have to set or reset the BOOT0.

Re: I have tested my code in blue pill and now have made my custom pcb containing stm32f103c8t6. I am unable to program with my st link. The ettings on stm32cubeide are correct as the code gets uploaded in the bluepill. Do we have to set or reset the BOOT0.

Re: I have tested my code in blue pill and now have made my custom pcb containing stm32f103c8t6. I am unable to program with my st link. The ettings on stm32cubeide are correct as the code gets uploaded in the bluepill. Do we have to set or reset the BOOT0.

Re: I have tested my code in blue pill and now have made my custom pcb containing stm32f103c8t6. I am unable to program with my st link. The ettings on stm32cubeide are correct as the code gets uploaded in the bluepill. Do we have to set or reset the BOOT0.