About PMial.2454

PMial.2454 · 2020-11-04

HelloI am using STM32CubeIDE 1.0.2 with CubeMX.Hardware: STM3240G-EVAL (Evaluation board with STM32F407IG)I have to use RS485 in the program.In CubeMX in UART options, I do not see the option "Hardware Flow Control (RS485).On the video https://youtu....

PMial.2454 · 2019-12-10

HelloI am trying to debug a project in STM32CubeIDE v1.1.0.Debug probe: ST-LINK GDB server.I get this error:"Error in final launch sequence:Failed to execute MI command:target remote localhost: 61234Error message from debugger back end:Cannot access ...

PMial.2454 · 2019-12-04

HelloI have a problem with USB working properly - USB CDC (Virtual Com Port) with CubeMX HAL after disconnecting the USB cable and connecting again.For the test I created a project similar to the one presented here - https://www.youtube.com/watch?v=A...

PMial.2454 · 2020-11-05

Paul@Port and Imen DAHMEN thank you for the answers, they helped me.

PMial.2454 · 2019-12-10

I am using STM3240G-EVAL evaluation board. This was a project ("test_usb_4") with default settings(STM32CubeMX) for this board and USB OTG FS as Virtual Com Port.The problem appears and disappears (in the test_usb_4 project) when:1. If in 'Debug Conf...

User statistics

User Activity

In CubeMX, how to enable "Hardware Flow Control (RS485)?"

Error message from debugger back end: Cannot access memory at address 0x... How to solve it?

I have a problem with USB working properly - USB CDC (Virtual Com Port) with CubeMX HAL after disconnecting the USB cable and connecting again.

Re: In CubeMX, how to enable "Hardware Flow Control (RS485)?"

Re: Error message from debugger back end: Cannot access memory at address 0x... How to solve it?