About pshin.2

pshin.2 · 2023-06-20

Hii,I am using STM32h745IIK6. I want to use my SPI clock as a timer to generate delay in microsecond how can i to that. Please help with tutorial or your guidance. Thanks in advance.

pshin.2 · 2023-03-20

Hiiii,I'm trying to create multicore communication in Nucleo-H745zi. I want to call interrupt in the second core. I just want toggle LED in second core after interrupt came from first core. I checked the articles and other stuffs on internet but i ca...

pshin.2 · 2023-03-01

I am using stm32f429iit6 customized board . I have one hex file , when i debug that hex file in board its working fine and not giving any usb issues its shows stm virtual com port , But when i write program for same board its giving the USB driver is...

pshin.2 · 2023-02-28

Hey there i am using FTP-628 MCL101 Thermal printer(https://www.fcl.fujitsu.com/downloads/MICRO/fcai/thermal-printers/ftp-628mcl101_21_50.pdf ) with STM32F429iit6.Please help me with the same.

pshin.2 · 2023-02-23

I have two boards Nucleo F429ZIT6 and STM32F429IIT6 . Both controller have same Data sheet , both have same USB FS pin. I write the code for stm32F429IIT6 and debug it in both of boards my nucleo board is working fine but my STM32F429iit6 board is no...

pshin.2 · 2023-03-22

Hey i don't want to use any memory , I just want to send any type of interrupt from CM7 to CM4 without using any type of memory . I used CM7 send interrupt to CM4 this and add /* Enable and set EXTI lines 15 to 10 Interrupt to the lowest priority ...

pshin.2 · 2023-03-07

I already go through it but its not working .

pshin.2 · 2023-03-02

Hey thanks for reply I have tried it also i increased my heap size to till 0x2000 but still its giving the same error and i also want to ask you that is it happening due to BSP ??

pshin.2 · 2023-03-02

Its an pre-programmed project file which i get with my customized board . Which is programmed by the other developer i really don't know about it much , but now i want to reprogram it .

pshin.2 · 2023-03-01

Hey .Please update your st-link firmware package and if its still not working , check sleep mode configuration , may be your mcu goes in sleep mode , 1) You have to ground the BOOT0 pin (check your nucleo's configuration) and 2) There is one more t...

User statistics

User Activity

SPI clock use as a timer

STM32H745 call event interrupt in second core

USB Not recognized in stm32f429iit6

How to interface thermal printer With STM32F429iit6.

What if i debug the STM32f429iit6 program in Nucleo F429zit6 ?? I debug it in nucleo and now nucleo's USB FS working fine but the same code does not working in controller(stm32f429iit6). why this is happening ??

Re: STM32H745 call event interrupt in second core

Re: What if i debug the STM32f429iit6 program in Nucleo F429zit6 ?? I debug it in nucleo and now nucleo's USB FS working fine but the same code does not working in controller(stm32f429iit6). why this is happening ??

Re: USB Not recognized in stm32f429iit6

Re: USB Not recognized in stm32f429iit6

Re: I am unable to establish communication between STM32CUBE IDE and Nucleo STM32L412 board.