About LSung.1

LSung.1 · 2024-04-05

Hello?As title, at STM32H750, when will be fix to use termperature sensor/vbat/vref? In version 1.15, all checkboxes were cleared. Due to migration, the lower version couldn't even read it, so I reset it from the beginning.And then, it seems that the...

LSung.1 · 2024-02-01

Hello.Three product packages are identified in the TS33's datasheet.Among these, the QFN-8 package has 5 NC pins. Is it okay to connect them to VIN or VOUT or GND?I couldn't find a additional explanation for the NC pin, so please check there is anyth...

LSung.1 · 2023-12-23

Hello?I am developing CAN communication with H7 series products, but I am experiencing inconvenience due to errors in STM32CUBE.In this program, the minimum value of Normal Time Seg1 and Seg2 is forced to 2.(Ver 1.14.0) However, it is confirmed that ...

LSung.1 · 2023-10-29

Hello?As the title, hUsbDeviceHS is one of the structures automatically created by STM32CubeIDE. Currently, I connect the USB port with this structure name, and I want to stop the USB port when there is a switch input. (I confirmed that the function ...

LSung.1 · 2023-10-28

Hello?If you just build from the Device Configuration Tool(*.ioc), an error will occur as shown in the picture below.(MCU: STM32F730, File:usbd_conf.c) The functions that enable clocking and the functions that enable ULPI clocking already exist above...

LSung.1 · 2024-04-05

Thank you for reply.In fact, I updated it with the expectation of debugging the improved live expression written in the release notes, but errors were added that did not exist, causing considerable trouble, so I wrote this article.I know that live ex...

LSung.1 · 2024-04-05

Same as below.

LSung.1 · 2024-03-30

When editing, it would be nice to add '#ifndef~#endif' for every '#define'.

LSung.1 · 2024-02-11

All I wanted to know was whether connection to other pins was possible.In the data sheets of many other products, there are cases where NC says 'no connect', but there are also cases where it says 'not connected'. So, like the product in question, it...

LSung.1 · 2024-02-08

Of course I think so, but because of the unnecessary NC pins, there are limitations to the artwork being done in a small area, so I wanted to check the manufacturer's answer.

User statistics

User Activity

STM32CubeIDE V1.15.0 H7 series ADC3 Problem.

Inquiry about AQP package (QFN-8) among TS33 series products.

What version will this error for seg1, seg2 of CANFD setting problem in STM32CUBEIDE.fixed in?

USB stopping method referring to hUsbDeviceHS created in STM32CubeIDE. (@usb_cdc_if.c)

How to prevent certain functions from being created.(Device Configuration Tool makes error)

Re: STM32CubeIDE V1.15.0 H7 series ADC3 Problem.

Re: STM32CubeIDE V1.15.0 H7 series ADC3 Problem.

Re: CDC device status sending: default setting is too small

Re: Inquiry about AQP package (QFN-8) among TS33 series products.

Re: Inquiry about AQP package (QFN-8) among TS33 series products.