In our design the Proximity sensor is locking up in 90% of the boards. It ranges properly on its own. But when added to the bus, rest of the sensors function properly and only VL6180X is locking up. This is an ongoing issue.In the boards where its fa...

Hi,I am trying to make the interrupt work on the the Y-Axis, X-Axis, or Z-Axis.Here are the outputs I am getting. Threshold set to 960 mg. So when it gets bellow that threshold I am looking for an interrupt on the Z-axis. 0.280: Acceleration [mg]:14....

We have designed a circuit using this chip with the 3.3 voltage rail . Without converting it to 2.8 as it is bellow the max thresh-hold as per the datasheet. We also pulled up the XSHUT pin high to 3.3v using a 10k ohm resistor. In theory it should p...

We are putting the VL53L0X in a device with a tinted lens cover. Example shown bellow. I wanted to know about the calibration process during manufacturing that is recommended in the Application note. Is the calibration different from each individua...