About PVand.9

PVand.9 · 2020-09-01

Debugging the STM32L053, the STM32CubeIDE (v.1.4.2 on MAC) asks to install the ST-link Server.I install the ST-link server (v1.3.0) on my mac, this seems to be successful, but for the STM32CubeIDE, nothing has changed and it keeps asking to install t...

PVand.9 · 2022-03-14

Thanks for the clarification!

PVand.9 · 2022-03-11

I have this too with all my projects. I returned to v.1.8.0. for the momentI have one .h-file that is included from several .C-files. Therefor I put this on the beginning of each .h-file:#ifndef PMT_H_#define PMT_H_ 1// declarations come here#endif /...

PVand.9 · 2020-12-17

I continues by choosing the OpenOCD as debug probe instead of the ST-link GDB server (in debug configurations - tab debugger). Here the debugging seems normal.

PVand.9 · 2020-12-17

@Community member I was convinced that I had read it somewhere, but cannot retrieve it. Maybe it was the table 40 in the reference manual that was misleading me. But in the text it is written that the OSC_OUT must be left "hi-Z". Thanks for pointing...

PVand.9 · 2020-12-17

I have the same situation on a NucleoL053 where a 8MHz signal is supplied to the STM32L053 on the PH0 pin. The PH1_pin seems not to be controllable and stays Hi_Z.

User statistics

User Activity

How can ST-Link Server be installed for use by STM32CubeIDE ?

Re: Multiple definition error after STM32CubeIDE 1.9.0 update

Re: Multiple definition error after STM32CubeIDE 1.9.0 update

Re: starting the debugger : (Read)Failed determine breakpoint type

Re: Can I use PH1 as GPIO if I config PH0 as HSE BYPASS Clock Source? The same question on PC14, PC15 for LSE. my chip is STM32H seriies. tks adv.

Re: STM32F407 - HSE Bypass using external clock.