About DAlta.1

DAlta.1 · 2023-05-02

Hello,I am a mechanical engineer that is studying Mechatronics as master degree. I am getting keen on embedded system after I have taken a course on operating systems on embedded systems. I have never used STM32 word and I have just received a stm32f...

DAlta.1 · 2023-04-19

Good afternoon,I would like to use the Sensor tile on which is running the en.fp-sns-allmems1 fw to directly record sensor measurements on the SD card. The idea is to power on the sensor tile, then dobletapping on the sensor tile to start recording d...

DAlta.1 · 2023-04-23

Hi peppea82,Could you please share the code on how you have integrated that library? I am struggling to do it and I'd appreciate reading you code to better understand@peppea82

DAlta.1 · 2023-04-21

Thank you for the answer.However I have vary poor skill in C and in embedded system. I am doing this for a university project. Could please share some example with me that guide me to some extent to do this ? I would appreciate a lot

DAlta.1 · 2023-04-03

Good Evening,I have the same problem as Chiara. I would set a sample rate of 100Hz or higher. If I wanted to modify ALLMEMS1 firmware to do that (perhaps telling that from the app and saving results on the SensorTile SD ), how would I do?

User statistics

User Activity

How should I study STM32 MCU

Is there any method to use en.fp-sns-allmems1 on the the sensor tile indipendetly from BLE application?

Re: MotionFX correct sequence

Re: Is there any method to use en.fp-sns-allmems1 on the the sensor tile indipendetly from BLE application?

Re: Change ODR on SensorTile