About Mric.1

Mric.1 · 2025-02-04

Dear board, Whenever I create a Trust-zone enabled stm32 project for an stm32h573xx microcontroller using cube ide or cube mx, upon code generation I get the warning:"The provisioning scripts are only supported for DK boards (Or custom boards with th...

Mric.1 · 2022-10-11

Dear community,I recently faced a possible anomaly in Stm32 cube configuration when setting up the RTC alarm:the rtc alarm interrupt was firing immediatley during initialization.Everything was setup via Cube, no manual code involved.Problem begins im...

Mric.1 · 2021-09-28

Hello communityI face the following problemI have a global data structure which contains several member variables, I use this data structure to handle all my global variables needs across my project.Such datatype is delcared in "globals.h", and a var...

Mric.1 · 2021-09-21

Hello community,I face the following problem on my NUCLEO F746ZG board :I want to power up my nucleo from an external source for my application, I have done as the Nucleo-144 manual suggests:Set the power line jumper JP3 to E5V or Vin (tried both)Rem...

Mric.1 · 2025-02-06

Bump

Mric.1 · 2024-03-06

STM32CubeIDE 1.14.1 the same problem is still there I have to comment out the include manuallystm32h5xx_hal_usart is not present in the header files in the drivers folder

Mric.1 · 2021-10-01

Thank you for your support you have been very kind! my problem is that I was not escaping the ":" char correctly now I use "../" to address the makefile to the project folder when adding sourcesMatteo

Mric.1 · 2021-09-29

Thank you Alexandre, can you also tell me what would be the synthax to add multiple include paths and source files? I tried to separate them with white spaces or -I but it does not work :grinning_face_with_sweat:

Mric.1 · 2021-09-22

Thank you, your suggestion works better than pulling up the RST, a jumper was installed on that solder bridge, but ultimately I had to add also a 1s delay before peripheral initialization to make everything run fine all the time!

User statistics

User Activity

Warning The provisioning scripts are only supported for DK boards

Hal Rtc alarm Interurpt firing at startup possible bug report on stm32wl55

Assigning external data structure variables in TouchGFX

Nucleo-144 Powering from external source doesn't work

Re: Warning The provisioning scripts are only supported for DK boards

Re: stm32h5xx_hal_conf.h is generated with #define HAL_USART_MODULE_ENABLED

Re: Assigning external data structure variables in TouchGFX

Re: Assigning external data structure variables in TouchGFX

Re: Nucleo-144 Powering from external source doesn't work