FAQs
KChie.1
Associate II
since ‎2021-07-05
‎2023-06-14

User statistics

  • 12 Posts
  • 0 Solutions
  • 0 Kudos given
  • 0 Kudos received

User Activity

X-Nucleo-IHM08M1 3Sh and Nucleo-F746ZG use MotorControl Workbench 5.4.5 Over current

2021-07-28
I use MotorControl Workbench 5.4.5 to control BLDC, but it always send error "over current". I check all setting but not have mistake in MotorControl.​The warning displayed by MotorControl Workbench is due to over current with my settings, but the Ma...

X-NUCLEO-IHM08M1 with NUCLEO-F746ZG can connect MCSDK warning overshoot current

2021-07-13
Sorry this is my first time to use MCSDK, I am not sure what can I do.I follow Motor Profiler to set my board, and I check my pin map with my motor.When I want to contorl my motor with MCSDK, it always warning over current.I am not sure I have to set...

Can MCSDK accuracy ±1RPM?

2021-07-07
My BLDC have Quadrature encoder. When I use MCSDK , I got RPM only multiples of 6, so it let motor control Steady-state error so big. How can I do that MCSDK get value can  accuracy ±1RPM?My board :STM32F407.​

MCSDK "Bus Voltage" is weird in case of NUCLEO-F746ZG and X-NUCLEO-IHM08M1.

2021-07-05
I try to control the BLDC with MCSDK. But when I connect the board, the voltage shows 17V. (At this time, I have not provided voltage to NUCLEO-IHM08M1) And I’m supplying a voltage of 24V, and the measured value is 34V.​Are there any details I missed...
Top