About SPesc.1

SPesc.1 · 2023-04-06

I have successfully flashed my BluePill Board with an STM32F103 chip using the STLINK interface of a Nucleo board. Now, I have replaced the chip with an STM32F302CBT6 and am trying to flash it. However, I get the error message 'Target no device found...

SPesc.1 · 2023-03-09

Dear community,I'm still facing an issue with my SD card slot on my STM32F410RB Nucleo Board while using the CUBE IDE. After resetting the microcontroller, I'm able to mount the SD card successfully again, but as soon as I remove the card, I'm not ab...

SPesc.1 · 2023-04-15

The bootloader strategy has changed in the STM32F30xx and BOOT1 is not necessary anymore. The boot memory (RAM, Flash or System memory) is selectable through an option bit.BOOT0 is connected to ground.I will continue to search for the error.

SPesc.1 · 2023-04-15

Yesterday, I received three pieces of STM32F303. Full of anticipation, I soldered one chip and tested it. Unfortunately, the result did not change. Still the same error message. After spending the night on the internet trying to find a solution, I so...

SPesc.1 · 2023-04-06

I will get a few 303s from the local supplier and then test them.

SPesc.1 · 2023-04-06

Is there a possibility that I have received three defective controllers at once?

SPesc.1 · 2023-04-06

I have gone through the document and I believe that it should work. Now, I have installed another new 302 with the same result. Is there a country restriction or something like that? I purchased the controllers from Mouser.

User statistics

User Activity

Can I replace STM32F103 to STM32F302 chip on bluepill?

STM32 Can't remount SD after replacing SD card

Re: Can I replace STM32F103 to STM32F302 chip on bluepill?

Re: Can I replace STM32F103 to STM32F302 chip on bluepill?

Re: Can I replace STM32F103 to STM32F302 chip on bluepill?

Re: Can I replace STM32F103 to STM32F302 chip on bluepill?

Re: Can I replace STM32F103 to STM32F302 chip on bluepill?