About Soundhar

Soundhar · 2023-04-12

I recently purchased a STM32MP135F-DK Board to develop a IoT application. I'm slowly learning my way though OpenSTLinux. but for a urgent need i need to develop a hand application demo. the product description says it also supports bare metal RTOS ...

Soundhar · 2022-11-10

I have recently brought a STEVAL-STLKT01V1 SensorTile kit in which LSM6DSM, LSM303AGR & LPS22HB are connected in 3 wire SPI on the SPI2 line of STM32L476. I pulled 4 CS lines to high at the beginning of the program and have set the SPI2 to Half duple...

Soundhar · 2022-02-22

Good Day, I got myself a pair of LoRa-E5 mini which has STM32WLE5JC single-core. I would like to program them in a way in which they would communicate by using a channel and address id to each other. kindly give me a refernce to how to program them i...

Soundhar · 2021-09-22

Good day! Im facing a issue on our board's L452 in specific when i program via stm32 cube ide my code tends to stop at my debug break points when its not in debug mode. i tried to remove all break points and make sure skip all break points enabled th...

Soundhar · 2022-02-28

Thanks for the reply. I will go through the SubG_Phy ping pong example. Since I'm more familiar with NRF modules and LoRa Modules like E32 which work with a channel and Address id. I thought that way of development would be easy for me to work. but ...

Soundhar · 2021-09-24

I'm using ST-Link Firmware. so i hope that's not the issue.as you mentioned the bug on Cube IDE 1.7.0. I tend to terminate my debug session with out suspending the debug session first. it may be the cause of the issue in my case. in future days i wil...

Soundhar · 2021-09-23

good day sir,i have tried info b on my debugger console at first i got break points on my all other projects got mentioned so i closed the other project except the project i was working on.for 'info b' i gotinfo bNum Type Disp Enb Address Wha...

User statistics

User Activity

How to Run on Bare Metal RTOS on STM32MP135F-DK Discovery Board?

How to set LSM6DSM in 3-wire SPI mode with the given C standard MEMS library

Using STM32WL as a LORA Radio

STM32 Cube ide Code tends to stop at break points when its not on debug mode.

Re: Using STM32WL as a LORA Radio

Re: STM32 Cube ide Code tends to stop at break points when its not on debug mode.

Re: STM32 Cube ide Code tends to stop at break points when its not on debug mode.