FAQs
CWatt.1
Associate
since ‎2021-06-09
‎2023-06-14

User statistics

  • 4 Posts
  • 0 Solutions
  • 0 Kudos given
  • 3 Kudos received

User Activity

How to configure HRTIM in Up-Down Counting Mode

2021-06-21
I am using STM32 G474RE with STM32CubeIDE 1.6.1 with HAL configurations. I would like to use HRTIM1: Timer A with TA1 and TA2 enabled. My goal is to control TA1 PWM on the Up counting of Center Aligned counting (up-down counting), and control TA2 PWM...

Are there any examples that configure and use the Burst Mode Controller for HRTIM? I did not see any under the example selector.

2021-06-15

Is there a way to configure HRTIM Dead time after initialization with HAL?

2021-06-15
I am using STM32CubeIDE 1.6.1 with HAL libraries for STM32 G474RE. I would like to dynamically change the Duty Cycle, Period, and Dead time values for the HRTIM1: Timer A after initialization using HAL. After initial configuration set up by STM32Cu...

HRTIM1 Timer A Fault Level is not detected and does not allow other Timers within the HRTIMER to go into a fault state

2021-06-10
Issue has been resolved.
Kudos from
View all
Top