Hi,I really appreciate the reactivity of the forum, thanks a lot.i have some questions:1- When i enable/disable LDC mode using S2LPTimerLdcrMode, and S2LpTimerFastRxTermTimer, i need to run command S2LPCmdStrobeReady and S2LPCmdStrobeRx after each en...

Hi,I know that RF transceiver is affected by obstacle.What's the scope of S2-LP RF transceiver with/without obstacle?Is there an analysis on S2-LP RF transceiver?Best Regards,Mohamed Amine.

Hi I need to export configuration from my S2-LP soldered on my board. I succeed to export S2-LP in eval board using S2-LP DK tools, but, i can't display S2-LP register soldered on my borad (can't connect to my board with S2-LP DK tools). Is there a s...

Hello,Is s2-lp RF module supports mesh? If yes, where can'i found mesh stack and how it can be used?​Is below application note describe how can'i configure s2-lp module to work on mesh network? https://my.st.com/resource/en/design_tip/dm00567382.pdf​...

Hello, Is s2-lp RF module supports mesh? If yes, where can'i found mesh stack and how it can be used? ​Is below application note describe how can'i configure s2-lp module to work on mesh network? https://my.st.com/resource/en/design_tip/dm00567382.pd...