About RSHAR.2

RSHAR.2 · 2022-07-04

Hi,I am working on STM32F777 MCU LQFP 176 Package.I need to confirm if i can use FMC interface with my EtherCAT chip FIDO5200 that uses 16-bit data lines and 4-address lines.Also I need to interface SRAM (parallel bus)that has 8-bit data and address...

RSHAR.2 · 2021-08-10

Hi ,I am using these following parts in my design,VN5E016AFH-E, VN7000AY, VN7003ALH, VN7140AJ, VN7140AS , VN7140AS12, VN820-ECould you please provide the YTEOL , MTBF, FIT data for these parts.Also, are these parts available to order now?Thanks & Reg...

RSHAR.2 · 2021-07-27

Hi,We have proceeded with STM32H735VGT6 in our design as it meets our requirements. Can u please confirm if this part is SIL3 functional capable?

RSHAR.2 · 2021-06-22

Hi,I am using low end STM32L0 series MCU, I need to display a minimal text message on the TFT LCD display.STM32L0 doesn't have LCD engine, so can we write a code with GPIOs and display a text message.Please provide your feedback on this.

RSHAR.2 · 2021-05-24

Hi,I am Reshma, based on my design requirements, my team has chosen STM32H7A3RG MCU . We want to confirm if this MCU will support, RGB565,RGB666, RGB888 display formats. Please find the attached high level block diagram for our requirement.Please fee...

RSHAR.2 · 2022-07-05

Understood the connections.But still I am not sure if I want to read data from FIDO chip and write data into SRAM or vice versaCan these both operations occur at same time?Please clarify

RSHAR.2 · 2022-07-05

Classification: ConfidentialHi,Thanks for your quick response.We understood from your response that data and address lines can be connected to FIDO and SRAM independently.D0 to D15 data lines connected to FIDO chip and D16 to D31 connected to SRAMInd...

RSHAR.2 · 2021-06-23

Hi,Then I can use a RGB to LVDS convertor between STM32L0 MCU and LCD display.If I'm using RGB to LVDS convertor to interface with LCD display, then can we configure GPIOs as RGB format (like 565 or 888) and give it to RGB to LVDS convertor and then ...

RSHAR.2 · 2021-06-23

Hi,The LCD I have considered is 10inch TFT display that supports LVDS interface and I2C for touch interface.So is it possible to drive this display with GPIO pins from the MCU with voltage levels within the display limit.I'm asking this because using...

User statistics

User Activity

STM32F777 Parallel Bus Interface

Reliability data and Availability of the parts

Is STM32H735VGT6 SIL3 FUNCTIONAL CAPABLE?PLEASE CONFIRM

Can we display a test message using GPIO pins without using Graphics engine on MCU

Could you please confirm if STM32H7A3RG supports RGB666, RGB888 to interface with 10inch TFT LCD display.

Re: STM32F777 Parallel Bus Interface

Re: STM32F777 Parallel Bus Interface

Re: Can we display a test message using GPIO pins without using Graphics engine on MCU

Re: Can we display a test message using GPIO pins without using Graphics engine on MCU