About TIvan.1

TIvan.1 · 2023-07-24

Hello,I am using STM32F303RBT on a custom board and am trying to communicate through SPI with LTC6811-1 with code generated through CUBEMX.I am able to send and receive the data fine when the data is not required to be sent in one burst (LTC6811 can ...

TIvan.1 · 2021-05-14

Hello,I have a problem with ADC and timer setup and I was hoping I could get a bit of help.I would like to sample two analog signals simultaneously with regular dual simultaneous mode. The only way this has somewhat worked for me so far is to use TIM...

TIvan.1 · 2023-07-27

I managed to get it to work with the because there was the other underlying issue not related to SPI timing. It is working currently with the code above. Also, It is strange that I have yet to see documented code which uses FIFO or something similar ...

TIvan.1 · 2023-07-24

Thank you for the interest!I have tried with your suggestion to write the whole array, but with no performance improvement with default CUBE library.I however managed to shorten the delay between bytes by writing a much simpler version of HAL_SPI_Tra...

TIvan.1 · 2021-05-24

Hi, It looks like the error was in continuous conversion mode being enabled on ADC2. Also, I have used DMA. Below is the code.static void MX_ADC1_Init(void) { ADC_MultiModeTypeDef multimode = {0}; ADC_ChannelConfTypeDef sConfig = {0}; hadc1.Ins...

User statistics

User Activity

SPI pauses between bytes using HAL_SPI_TransmitReceive()

STM32F103C8T ADC triggering problem in regular dual simultaneous mode.

Re: SPI pauses between bytes using HAL_SPI_TransmitReceive()

Re: SPI pauses between bytes using HAL_SPI_TransmitReceive()

Re: STM32F103C8T ADC triggering problem in regular dual simultaneous mode.