by some mistake, we have a large batch of boards with LIS2DS12 sensor and STM32G030F6P6 mcu powered with 3.3 volts. but the maximum voltage for LIS2DS12 is 2.0 volts, and absolute minimum voltage for STM32G030F6P6 is 2.0 volts. so we tried to adjust ...

I set ACT_THS and ACT_DUR registers, so now the chip enters on low data rate mode (10 Hz) when no movement is detected. everything is fine to that point. I don't have access to INT1 and INT2 pins physically so I need to read activity/inactiviy statu...

hi i am using STM32L071KZT6 chip in my board and using Cube ide for initialization and code development. in the datasheet it says KZT6 chip has 1 clock input and is configurable as HSE/LSE/HSI/MSI/LSI but in the Cubeide clock config page or System ...

can i use unico gui and Algo builder without STEVAL-MKI109V3 (and series) i havenucleo F401RE and X-Nueclo IKS01A1 - X-NUCLEO-IKS01A2