Hello allI use ST25DV64K.​If I2C communication is used to access EEPROM while APP is writing to EEPROM, it will cause an error on APP side.Therefore, I would like to check the status of the NFC tag when it is being written from APP.And while writing ...

Hello allI use ST25DV64K.If the I2C communication is normal, it returns ACK after receiving data, and after receiving the last data, it returns NACK response and issues Stop Condition.If the I2C communication is abnormal, and the master issues a stop...

Hello allI use ST25DV64K.I am always set the MB_MODE of ST25DV64K to 1 after power-onAfter setting the value to 1, a verify check is performed to confirm that the value is set to 1.And the result MB_MODE is 1.When the power is turned on again after t...

I am using a ST25DV64K.I am trying to exchange data between the MCU on the board and Mobile Phone using I2C/RF and FTM.The RAM capacity of the MCU on the board is small, and I am trying to divide the RF Message and read it.For example, I am trying to...