About WMaca

WMaca · 2020-07-01

Target: NUCLEO-WB55.Nucleo

WMaca · 2020-06-26

WMaca · 2019-04-03

----------- Project ild004v2 - STM8 Cosmic - Configuration Debug -------------Compiling watchdog.c...cxstm8 +modsl0 +debug -pxp -no -pp -l -i"x:\bu_thyristor_triac_rectifier\04_ase_thyristor_triac\promotion tools\digital dimmer with viper_steval-ild0...

WMaca · 2019-01-23

Looking to connect st-link-v2 debugger to my STM32F030F4P6TR chip. What pins needed to connect?

WMaca · 2019-01-14

WMaca · 2019-04-04

Thanks, originally working in STM8S103F2P. But when I change to bigger ram chip STM8S103F3P, already have the problem.

WMaca · 2019-01-28

I tried to load the demo firmware from ST using ST visual programmer but I got the error below.Error : Cannot communicate with the device !Check the SWIM cable connection and check all the needed pin connections on the SWIM connector.If the applicat...

WMaca · 2019-01-14

Hi,So, it is not popular. Are you suggesting using the STM32 for this application?Regards,Walter

WMaca · 2019-01-13

Hi, I am looking for the source code also. Is this one a compiled firmware or this can be modified using the IDE? Regards,Walter

User statistics

User Activity

why STM32 cube programmer show Error: --reserved -- when loading coprocessor binary stm32wb5x_FUS_fw.bin with start address 0x080EC000?

Where to get the BLE sdk for STM32WB55CG? https://www.st.com/content/st_com/en/products/microcontrollers-microprocessors/stm32-32-bit-arm-cortex-mcus/stm32-wireless-mcus/stm32wb-series/stm32wbx5/stm32wb55cg.html#tools-software

I am using STEVAL-ILD004V2 source code for dimmer. I can compile using my ST Develop using STM8 cosmic compiler when no change. But, when I change MCU to STM8S103F3P. I will have this compile problem below. Regards, Walter

STM32 MCU Programming connection to st-link-v2 debugger.

Hello, Where to get the Source Code of the EVAL Board STEVAL-ILD004V2 with STM8S103F2 Controller? Can anybody help me? Best Regards, Walter

Re: I am using STEVAL-ILD004V2 source code for dimmer. I can compile using my ST Develop using STM8 cosmic compiler when no change. But, when I change MCU to STM8S103F3P. I will have this compile problem below. Regards, Walter

Re: Hello, Where to get the Source Code of the EVAL Board STEVAL-ILD004V2 with STM8S103F2 Controller? Can anybody help me? Best Regards, Walter

Re: Free IDE for STM8 development

Re: Hello, i'm searching for the Source Code for the Eval Board STEVAL-ILD004V2? There is only the compiled Firmware Version. Can anybody help me?