About SRoy

SRoy · 2024-04-19

Hello,I am currently Using STM32F779NIH6 for one of our application prototypes. Currently the internal RAM size is 512KB and based on our evaluation, for certain peripherals we need a higher RAM size ( Atleast 2X or 3X). Can you suggest any Controlle...

SRoy · 2024-01-23

Hi,I would like to know what is max number of SPI slaves I can connect to a single SPI bus of STM32F779? I understand that using the chip select pin I can select respective slaves to operate. But is ther eany recommendation from ST that ideally , I s...

SRoy · 2019-03-12

SRoy · 2019-03-07

SRoy · 2019-01-03

SRoy · 2019-03-17

@KIC8462852 EPIC204278916 This is the EEPROM present on the STM32F779 Eval kit.Due to shortage of time ,I donot want to go for another EEPROM as I already have the driver for this.Hence,I only want to make sure that if I go with M24LR, I should not f...

SRoy · 2019-03-16

JL. Lebon : Hello,On my PCB, there is no Antenna. I have kept the AC0/AC1 pin NC(Not Connected). Is this fine?Also, let me know if I keep RFbusy and Vout Pins NC as well since I am going to use only the I2C interface.Please suggest.

SRoy · 2019-03-14

@JL. Lebon_O Thank you very much for the reply. So what I can conclude from your answer is that there is no danger of unwanted emissions when I go for my RE test. Also, I would like to know is there any chance of malfunctioning of the device when it...

SRoy · 2019-01-02

Do I need to use any encoder IC along with the General purpose timers to achieve the encoder mode,or the timer is self sufficient to perform the encoder mode action.

User statistics

User Activity

Pin to pin compatible option against STM32F779NIH6

How many devices can be connected on SPI bus

How to disable the RF section in M24LR64E-R. I am using only I2C interface for my application and I want to avoid any unnecessary radiation from the chip

I am using STM6601CA2BDM6F push button controller in one of my device development projects. I would like to know if I can use this IC for delayed shutdown.

Can the internal flash of STM32F7 MCU be programmed through UART/USART using ISP

Re: How to disable the RF section in M24LR64E-R. I am using only I2C interface for my application and I want to avoid any unnecessary radiation from the chip

Re: How to disable the RF section in M24LR64E-R. I am using only I2C interface for my application and I want to avoid any unnecessary radiation from the chip

Re: How to disable the RF section in M24LR64E-R. I am using only I2C interface for my application and I want to avoid any unnecessary radiation from the chip

Re: STM32F7: Timers in encoder mode