About DWise.1

DWise.1 · 2024-06-05

The STM32CubeMX has a Clock Configuration page that can be captured in the "Generate Reports"I like to Print this page to configure clock timings and divide counters. The problem is that many of the values are very light, the ones that you can't cha...

DWise.1 · 2021-09-01

I am using STM32F303REx to measure Voltage and Current from ADC (differential Input). Is there -+ values around 0 or are they offset around 4096/2 Offset that must be subtracted to get a signed value? Is there any documentation or Examples?

DWise.1 · 2021-03-10

DWise.1 · 2023-12-15

I am developing with the same board. After much trial and error, using the above tactics works, but only if you have the system clock at 550MHz and set the core clock of SWV to 275.0 MHz. If the system clock is set to another value and the SWV clock...

DWise.1 · 2021-03-10

I have used the Configurator to pick parts, but if I indicate 2 ADC, it will include parts with 1 ADC and 2 or more channels (I bought F4 Nucleo boards and discovered this). Then I bought some H7 boards and they have 3 ADC's but they can't be config...

User statistics

User Activity

Clock Configuration Report

I am trying to find any information about what the values I would read using Differential inputs from ADC's on STM32F303. IS there Documents about Differential input (what the output would be)?

I am working on a project to read AC power. To do this accurately, I need the Voltage and Amperage to be read at the same time. I see the STM32F303 does this with simultaneous mode. which stm32 cores support ADC dual simultaneous mode?

Re: NUCLEO-H723ZG ITM printf / SWV problems

Re: I am working on a project to read AC power. To do this accurately, I need the Voltage and Amperage to be read at the same time. I see the STM32F303 does this with simultaneous mode. which stm32 cores support ADC dual simultaneous mode?