I am referring to the 2:1 balun T6 (BD0810J50100AHF) that transforms the incoming tag response to a 100 differential signal that is fed into ST25RU3993 receiver section at pins MIX_INP (pin 4) & MIX_INN (pin 6).Based on the datasheet of the balun, it...

Dear ST engineers,To my understanding, the use of the power detector component is to help the MCU determine the actual power output from the reader (before entering the antenna). May I kindly check with you the reason behind the selection of the mode...

Hi everyone,I am currently testing the UHF RFID board from ST (ST25RU3993-HPEV) and the eval board is using STM32L476RGT6 (Arm®(a) 32-bit Cortex®-M4) as the MCU. Our testing so far has been good and we would like to design our own RFID reader based o...

Currently I am working on a project that uses the UHF RFID evaluation board ST25RU3993-HPEV, which is controlled by STM32L476RG.For my project, I want to use Raspberry Pi to communicate with the evaluation board, so the use of Python is required. How...